Service
Paint & Wall Finishes
Surface preparation done properly, then the finish.
Most paint failures are preparation failures. We putty, sand, prime and only then apply — emulsions, textures, stencils, metallics and Venetian plaster.
What is included
- Interior and exterior emulsion
- Texture, stencil and metallic finishes
- Venetian plaster and lime finishes
- Wood polish, PU and duco spray finishes
- Full surface preparation: putty, sanding, primer
Get a number
Priced against your drawing
Every quotation is itemised by material, finish and hardware brand — so you can compare it line by line against anyone else's.
Request a quotation Try the cost estimatorHow it runs
From measure to handover.
Measure & draw
Site is laser-measured and converted into production drawings. Every panel gets a number before anything is cut.
Nest & cut
Panels are nested for minimum waste and cut on a panel saw / CNC to ±0.5mm. No hand-sawing, no site cutting.
Edge-band & drill
Automatic edge-banders seal all four edges with 0.8–2mm PVC. CNC drilling puts every hinge and shelf pin in exactly one place.
Dry-assemble & QC
Units are assembled in the factory, hardware fitted and checked, then knocked down and packed. Faults are found here, not in your home.
Deliver & install
Flat-packed, labelled and delivered. The in-house install team assembles, levels and aligns on site — days, not weeks.
Snag & hand over
Joint snag list, corrections, deep clean and a documented handover with warranty and care instructions.
Next step
Start with a drawing and a number.
Send us your floor plan or just your carpet area. You get a scope, a specification and a written quotation — free, and with no obligation to proceed.