Service
Modular Carpentry
Kitchens, wardrobes, storage — built on the factory floor.
Every carcass and shutter is cut, edge-banded and pre-drilled on machines, then dry-assembled and quality-checked before it leaves the factory. Site work is assembly only — no sawdust, no on-site improvisation, no wavy edges.
What is included
- Modular kitchens — base, wall and tall units
- Wardrobes, walk-ins and loft storage
- TV and crockery units, study and vanity units
- CNC-cut carcasses with 2mm laser edge-banding
- BWP / marine ply cores, branded soft-close hardware
Get a number
Priced against your drawing
Every quotation is itemised by material, finish and hardware brand — so you can compare it line by line against anyone else's.
Request a quotation Try the cost estimatorHow it runs
From measure to handover.
Measure & draw
Site is laser-measured and converted into production drawings. Every panel gets a number before anything is cut.
Nest & cut
Panels are nested for minimum waste and cut on a panel saw / CNC to ±0.5mm. No hand-sawing, no site cutting.
Edge-band & drill
Automatic edge-banders seal all four edges with 0.8–2mm PVC. CNC drilling puts every hinge and shelf pin in exactly one place.
Dry-assemble & QC
Units are assembled in the factory, hardware fitted and checked, then knocked down and packed. Faults are found here, not in your home.
Deliver & install
Flat-packed, labelled and delivered. The in-house install team assembles, levels and aligns on site — days, not weeks.
Snag & hand over
Joint snag list, corrections, deep clean and a documented handover with warranty and care instructions.
Next step
Start with a drawing and a number.
Send us your floor plan or just your carpet area. You get a scope, a specification and a written quotation — free, and with no obligation to proceed.